Talking about the method of linear correction of Cohen electronic balance

Put the SWA , switch in the ADJ position

Press the "MODE" "BL/V" button immediately after power-on. After the self-test, "98015" ( indicating the version number ) appears . Press "MODE" "UNITS" at the same time . After the resistance (39853) appears , tap it. Press the " ← " button to display "01.1" , and quickly become anti-resistance, put the weight on it, hold down the " ← " button after stabilization , and the "02.1" becomes anti-resistance, so 10 times, to display OR2 , take the weight, hold down the " ← " button, and self-test to zero.

(After the self-test is reset to zero, you can also press the "MODE" "BL" button to enter the modified version weighing )

Such as: 300g electronic balance linear correction point is * 5g , the second 55g , the third 105g , so double to 455g .

　 Put the SWA , switch in the ADJ position

Start up, press the "MODE" "BL/V" button after the self-test returns to zero, the version "98015" appears .

Press the "MODE" button to display 0:00000 and enter 030009 ( overload value ).

Press " → o ← " once, 0:00000 appears , enter 030000 ( full scale )

Press the " → o ← " key once to appear 0:00000 , input 120000 (1 , indicating the sense, 2 , indicating the decimal point position )

Press the " → o ← " button once the self-test is reset to zero. Press the "MODE" button to display the full-scale value, and fill the load code. When the second button is pressed, SYS will take the weight to zero.

Note: When entering the password, MODE/UNITS is the shift key BL/V is the number key ← is the confirmation key

Press the " → o ← " button first to display OXO and press ← (X indicates a certain number )

Correcting internal short circuit before turning the feet SC2440 ④⑤